- Slings: 100% nylon li>
- Threads: Liberty® (Netherlands), nylon filament bondirovannye li>
- Material: Cordura® 500d (100% nylon) li>
- Velcro: Alfatex® (Belgium) li>
- Weight: 29 g li>
- Size: 14,5-5-2,5 see li>
ul>
* Manufacturer reserves the right to make changes in design, materials and assembly of its products without prior notice p> p>
Pouch Velcro at one store for modern pistols (TL, APS, Glock 17, SIG-Sauer P226, etc.). With the ability to adjust the height and lateral utjazhki. Also it can be used to carry various large folding knives, lamps, etc. objects (dimensions - height of about 12-14 cm in diameter and 3 cm). Not compatible with shops and multitool PM (too short), it is recommended to purchase a pouch or small multitool. gas. bottle b>
- Mounting: a removable belt clip, batteries not included. For mounting on the classical system PALS / MOLLE necessary one b> cell in width and two b> horizontal rows of cells in height. Attention! To fix the pouch must be purchased one clip of the following types: li>
ul>
- For platforms PALS / MOLLE and widths up to 50 mm inclusive: b>
2M MOLLE 75mm
3 "TacTie (Maxpedition)
MALICE Short (Tactical Tailor)
FixClip 3 "(Kiwidition) li>
- For belt widths up to 60 mm inclusive: b>
2M MOLLE 60mm
- belt width 58-60 mm (eg belt US): b>
ALICE
2M MOLLE 60mm li>
ul>
- Pouch is designed for a tight fit Store li>
- pouch sewn entirely of two layers of fabric for strength Cordura® 500d li>
- From the main compartment pouch looks at least 3 cm in height pistol magazine, which is convenient for removal li>
- The cross section is pulled pouch sewn 35 mm band. Thanks utjazhki Store tightly held in pouches, even with an unbuttoned valve (the valve can no longer needed to fill a shop that require fast access). Eraser is located below the entrance of the pouch, allowing the entrance expands the neck up, facilitating the introduction of shops li>
- pouch fastens with Velcro. Velcro on the haversack longer than the valve. It is necessary for a firm grip on all possible areas when adjusting for shops of varying heights li>
- At the end of the valve 2 cm oven mitts for easy unfastening pouch even when wearing thick gloves li>
- All Velcro sewn in two passes around the perimeter of or in addition to the reliability of the diagonals li>
- At the bottom there is a grommet for drainage of water li>
ul>
p>
REVIEWS: b> p>
- Forum Discussion li>
ul>
You might be interested: b> p>
ul>
- Forum Discussion li>
- For belt widths up to 60 mm inclusive: b>
- For platforms PALS / MOLLE and widths up to 50 mm inclusive: b>
- Mounting: a removable belt clip, batteries not included. For mounting on the classical system PALS / MOLLE necessary one b> cell in width and two b> horizontal rows of cells in height. Attention! To fix the pouch must be purchased one clip of the following types: li>