- Slings: 100% nylon li>
- Threads: Liberty® (Netherlands), nylon filament bondirovannye li>
- Material: Cordura® 500d (100% nylon) li>
- Accessories: Duraflex® li>
- Weight: 73 g li>
- Size: 19-6,5-5,5 cm (taking into account the thickness of fasteksy, contains the minimum height) li>
ul>
* Manufacturer reserves the right to make changes in design, materials and assembly of its products without prior notice p> p>
Универсальный pouch to carry a variety of pyrotechnic articles - one DBR (hand smoke grenades), a PMA (jet flares) or two RSP (jet cartridges signal). At fasteksy, with adjustable height and lateral utjazhki. It is also well suited for two 30-round magazine 9-19 PP-19-01 Vityaz / Saiga-9 b>
- Mounting: UniClick third generation system. A built-in clip. For mounting on the classical system PALS / MOLLE necessary one b> cell in width and two to three b> horizontal rows of cells in height. This clip narrowed haversack (20 mm) for easy installation li>
- The cross section is pulled by three rubber bands, ribbons, distributed evenly over the entire height of the pouch. This allows you to reliably capture a narrow CPR upright, preventing him to fall to the side of the valve under the pouch and prevents loss of items with the valve open li>
- pouch fastened on fasteksy Duraflex® with adjustable height. Mother fasteksy sewn to the edge of the pouch and the valve operates as oven mitts handy for quick opening li>
- At the entrance to the front pouch sewn loop-manners of the slings. Pulling it forward, you can ease the introduction of the subject li>
- All the tissue sections and lines are hidden under the stitches or edged for safety and neat appearance li>
- At the bottom there is a grommet for drainage of water li>
ul>
p> - The cross section is pulled by three rubber bands, ribbons, distributed evenly over the entire height of the pouch. This allows you to reliably capture a narrow CPR upright, preventing him to fall to the side of the valve under the pouch and prevents loss of items with the valve open li>
- Mounting: UniClick third generation system. A built-in clip. For mounting on the classical system PALS / MOLLE necessary one b> cell in width and two to three b> horizontal rows of cells in height. This clip narrowed haversack (20 mm) for easy installation li>