* Manufacturer reserves the right to make changes in design, materials and assembly of its products without prior notice

pouch for two 30-round magazine AK74 or AKM. Replaces Pouch to 2 mag. AK Velcro adjustable, with a number of improvements. Has a custom utjazhki volume and removable height-adjustable flap with Velcro. It is possible to use pouches without the valve for easy access to shops

• Mounting: System UniClick third generation. Two built-in clip. For mounting on the classical system PALS / MOLLE must be two cell width and two to three horizontal rows of cells in height. This clip narrowed haversack (20 mm) for easy installation
  
  
• Suitable for shops M4 fitted with the manners MAGPUL® ORIGINAL
  
  
• pouch sewn entirely of two layers of fabric for strength Cordura® 500d
  
  
• From the main compartment pouch looks at least 5 cm height of the store, which is convenient for removal
  
  
• Dimensions are spacious enough for easy insertion and extraction of shops, including the option of placing the lid down
  
  
• The cross section of an elastic cord is pulled pouch large type with adjustable clamp Duraflex®. The cord is much stronger than the usual broad gum, it can be adjusted or removed completely, it is repairable. Thanks utjazhki pouch may even without buttoned valve securely hold one or two shops
  
  
• In the front wall of the pouch between two layers of fabric sewn into a piece of plastic. It supports form pouches and significantly facilitates the introduction and removal of stores. In addition, the hard plastic does not greatly deform the elastic cord to pull the front wall, which could hamper the introduction of shop inside
  
  
• pouch fastens with Velcro. Velcro on the haversack longer than the valve. It is necessary for a firm grip on all possible areas Velcro equally well for two stores and one (because the valve is displaced vertically)
  
  
• The valve is fastened to the Velcro inside the back wall of the pouch. Place fastening, you can choose the height, the height is adjusted so buttoned pouch in the form of (for different kinds of shops). It is recommended to adjust the valve so that the top edge of the valve Velcro coincides with the upper edge of the Velcro on the response to buckle haversack pouch with two shops inside. When Releasing the valve may need additional tools, such as a metal line, which must be placed between the mating Velcro
  
  
• Wearing a valve further sling is held horizontally on top of the pouch, she plays the role of protivootryvnogo element. Also under this sling can fill the end of the valve to quickly translate pouch mode fast access to the shops (see. Photo in the catalog), it will not interfere. Both ends of the narrowed valve for easier by inserting a sling
  
  
• In the center of the valve from the inside sewn 25mm Velcro, allowing fold and fasten to the valve itself, if it is not used (fast access to the shops)
  
  
• On the edges of the valve from the inside sewn narrow straps, not giving the angular top stores AKM slip sideways out of the valve, as well as stiffening the edges of the valve
  
  
• At the end of a long valve (8 cm) manners of slings with a thickening on the end for easy unfastening pouch even when wearing thick gloves
  
  
• All the tissue sections and lines are hidden under the stitches or edged for safety and neat appearance
  
  
• All Velcro sewn in two passes around the perimeter or additionally diagonally reliability
  
  
• At the bottom there is a grommet for drainage of water